Surfsight - Inserting / Replacing a SIM Card

Surfsight - Inserting / Replacing a SIM Card

Inserting or replacing a SIM card

You can also watch a (short) video of this process at the bottom of this section.

  1. Remove the protective cover with the screwdriver provided to you.

image52.png

  1. If replacing a SIM card, remove the old SIM by pushing down and then sliding it out.

  2. From the shipping card, pop out your new SIM to a micro-SIM size.

image53.jpg

  1. Insert the new card by pushing it down into place. It should not stick out.

Testing the new SIM card

  1. Connect your dashcam to a power source.

  2. Enter your PIN on the screen.

Note

Contact your reseller if you do not know your PIN.

  1. Check the touchscreen to see network connection bars. The connection is active when there is no X across the bars.

  1. If there is an X across the bars, the SIM may be fine, but you might be in a location with a poor network. When there is no X, the signal should be sufficient for all functions to run.

image54.png

  1. If the network connection is active, replace the protective cover using the specialty screwdriver.