Follow These Steps:

1. Locate the vehicle's engine diagnostic port typically found in the driver's area at or below knee level.
2. Align the receiver end of the device with the engine diagnostic port (or use the T-harness if applicable) and push in place.
3. Please ensure the device is well connected to the diagnostic port. Once connected, the device emits 6 quick beeps.
4. Once the device is connected and receives power, the LEDs on the front of the device start blinking then turn solid once completing the actions below.
   Red LED - Device Power Source.
   Green LED -  Cellular network connectivity.
   Blue LED -  GPS network connectivity.
5. The device emits two quick beeps every 60 seconds during set-up. Initial startup may take several minutes to complete. Once all three LED lights turn solid and you hear 10 quick beeps. The device starts updating when the green and blue LEDs turn solid.
   • 

6. Keep the ignition of the vehicle on for 12 to 15 minutes so that the Go device can download the firmware.

7. The firmware will then be applied while ignition is off.

8. Navigate to your Geotab portal to verify that the device is communicating.
   

1. If this is a new device, click the blue "+ Add a New Asset" button on the top right of your Geotab Assets page, then follow the instructions to add the new Asset name and assign the Geotab serial number.
   

2. If you are replacing a device on an existing asset, open that asset's information page, scroll down to the Geotab serial number field, and click "replace with new device" and update with the Geotab device serial number.
   

Additional Notes

• Instructions for installing a GO device can be found on the Installation Documentation page of Geotab's website. On this page:
  • Scroll down to locate the desired Go Device Model Install link. (i.e GO9 Install).
  • The link will take you to:Telematics & WiFi Device Installation & Warnings.
• To secure the Go Device in place, we have accessories such as Zip Ties and Mounting Brackets:
  • You can find these items in the following document for ordering purposes.
  • Harness Identification and Application.
• Please review this video for additional assistance on how to install the GO Device: How to Install Geotab's GO Vehicle Tracking Device.
• Please make sure the device serial number is added to MyGeotab database either by adding a new vehicle/Asset in the databaseor by replacing the device serial number on an existing vehicle .
• For the general overview of database, user, and vehicle setup, please see How do I get started with Geotab after receiving devices?