Geotab - GO9 Device Light Indicators and Initial Install Beeps

Geotab - GO9 Device Light Indicators and Initial Install Beeps



Troubleshooting LED Flashes & Diagnostic Sounds

Upon installation, the device will go through a several beeping sequences while going through the connection phases. Below are the beeps and LED flashes in order of when you should hear/see them and what to do if they don’t happen.

Connection Stage

Audio & Visual Confirmation

Troubleshooting

Power Detection

6 beeps

Confirm connection.

Check for blown fuses.
Try another device.

Ignition Detection

1 short beep

Red LED flashes

Confirm correct harness is installed.

GPS Latch

1 long beep

Blue LED flashes

Ensure vehicle is outside with a clear view of the sky.

Move device on top of dash or away from metal surroundings.

Cellular Latch 1

2 short beeps

Ensure there is cell coverage.

Ensure SIM is active in install tool.
Move device on top of dash.

Cellular Latch 2

3 short beeps

Green LED flashes